|
 
The repair or overhaul of these components is accomplished at the Repair Station's facility in Fort Worth, Texas, which is conveniently located near Dallas/Fort Worth International Airport. The facility has over 45,000 square feet of working area, all of which is climate controlled.
Below is a list of the equipment on site that Texas
Air Composites utilizes for the repair / overhaul of aircraft parts:
- 4' Sheet Metal Brake
- 4' Sheet Metal Shear
- Adhesive prime booth (8' x 12'
- Air Compressor (25 & 30 hp)
- Autoclave (6' diameter inside x 18' long; capable of 400 F &
100-PSI)
- Bridgeport Machine
- Clean Rooms (26' x 56' & 16' x 20')
- Etch Line (7' deep x 4' wide x 15' long)
- Flame Spray Equipment
- Forming Press (48" x 96" & capable of 100 ton)
- Grinding Booth (10' x 20')
- Heated Press (4' x 4')
- Hot Bonder (Wichitec Two Zone)
- Laminating Presses (18" x 18" & 24" X 24";
both capable of 3500 F and 100-PSI bond line pressure)
- Lathe Machine
- Media Blast Cabinet (3' x 3')
- Measuring Equipment (capable of tolerances to .000)
- MIG Welding Machine
- Paint Booths (8' x 25' & 8' x 12')
- Small Parts Oven (1' x 2' & capable of 4500 F)
- Thermoplastic Vacuum Forming Machine (36" x 36")
- TIG Welding Machine
- Vacuum Pump (15 hp)
- Walk in Freezer (8’ x 8’ x 12’ & capable of –15
F)
- Walk in Oven (8’ x 8’ x 12’ & capable of 4500
F)
|
